Cadac R-Type Manuel d'utilisateur télécharger pdf (Page 73)

Stereo Input Channel 8231 8-7

Revision R2005-2 R-Type

L-R and Stereo Bus

Jumper 33 sums the Left and Right input signal which then inputs to the PAN control,

allowing a summed mono signal to be panned between Left and Right on the L-R

and Stereo busses.

Removing jumper 33 allows a true stereo signal to bypass the PAN control allowing

the Left signal to feed the left side of the L-R and Stereo bus only, and the Right sig-

nal to feed the right side of the L-R and Stereo bus only. (With this jumper removed

the PAN control will be inactive.)

;1415; 3$1#&RQWURO

The PAN control affects 4 (depending on the settings of internal jumpers) different

sections of the module:

a) L-R Stereo Bus

Jumper 33 on the stereo module motherboard sums the Left and Right input signals

which then inputs to the pan control allowing a summed mono signal to be panned

between Left and Right on the L-R and Stereo busses.

Removing jumper 33 allows a true stereo signal to bypass the PAN control allowing

the Left signal to feed the left side of the L-R and Stereo bus only, and the Right sig-

nal to feed the right side of the L-R and Stereo bus only. (With this jumper removed

the PAN control will be inactive.)

b) Aux/Groups 9-16

Jumper 34 on the stereo module motherboard sums the Left and Right input signals

which then input to Aux/Group sends 9-16, allowing a summed mono signal to these

Aux/Groups.

Removing jumper 24 AND enabling the “Stereo Pan to Grps” switch (located under

the pan control) allows a true stereo signal to input to the groups, that is the Left

input to feed the A send and the Right input to feed the B send.

c) Aux/Groups 1-8

Regardless of jumper options, Aux/Grps 1-8 can be set to true stereo by activating

stereo mode from the CCM. Select “SYS” then “User Setup” followed by “Bus Config”

and the up/down keys to select the bus number and the Enter key to toggle between

mono/stereo mode.

d) Direct to Matrix switches

Regardless of jumper options, by default the odd number switches, 13 and 15 will

output the Left signal to the 13 and/or 15 matrix output and even numbered switches,

14 and 16 will send the Right signal to the 14 and/or 16 matrix output. Enabling the

“Mtx Stereo pan to” switch (located under the PAN control) will send a summed mono

signal to the Matrix outputs via the PAN control.

;1415< 6WHUHR

Sends the post-fade signal via the pan control depending on the internal jumper set-

tings (see 7.1.28 PAN Control) to the stereo L-R outputs located on the PFL/Listen

module. This is a separate and additional stereo bus from the main LCR outputs

located on the LCR module. The LCR-switch has no effect on the operation of this

additional bus.

L-R and Stereo Bus

Jumper 33 sums the Left and Right input signal which the inputs to the PAN control

allowing a summed mono signal to be panned between Left and Right on the L-R

and Stereo busses.

1 2 ... 68 69 70 71 72 73 74 75 76 77 78 ... 138 139

Commentaires sur ces manuels

Pas de commentaire

Cadac R-Type Manuel d'utilisateur Page 73

Commentaires sur ces manuels