Cadac R-Type Manuel d'utilisateur télécharger pdf (Page 34)

4-6 How to use the R-Type

R-Type Revision R2005-2

■

■■

■

Press the SET button on the FCM

The DC and SET buttons will start to flash and the SET buttons on all outputs will illu-

minate. The DC LED in the array of LEDs on the DC Master will also illuminate, indi-

cating that DC assignment can start.

■

■■

■

Select the DC Master (using the numerical buttons on the FCM) to which you

want to assign the output channel or matrix output.

■

■■

■ Press the VCA switch on the desired output or matrix.

■

■■

■

Press the SET button on the selected output channels once. The LED associ-

ated with the selected DC Master will illuminate.

Please note that both output & matrix and the matrix output in each module share a

common DC Master assignment. Also, the output & matrix VCA LED-section is inde-

pendent of the VCA fader.

71915 +RZ#WR#DVVLJ Q#DQ#RXWSXW#WR#D#PDWUL[#RXWSXW

■

■■

■

Press the desired D/O matrix button 13-16 at the top of the input channel module

■

■■

■

Adjust the level using the matrix O/P level pots on the output & matrix modules.

71916 +RZ#WR#DVVLJ Q#DQ#RXWSXW#WR#WKH#6WHUHR#RXWSXW

To use the dedicated stereo bus and its output, press the Stereo button on the input

channel. This routes the signal to the Stereo output on the Listen module via the

module stereo master faders. This assigns a channel to the stereo output.

To assign an output to the Listen module, press the stereo buttons on the sub out-

puts.

71: +RZ#WR#62/ 2#D#FKDQQHO

■

■■

■

Press the MUTE button on the selected input channel

■

■■

■

Press CHECK on the Osc and Comms module

WARNING:

Using destructive SOLO in this way mutes every module in the console.

This SOLO-in-place means SOLO will continue to have its panning information. Both

L-C-R and Stereo outputs are affected when pressing the CHECK button.

71; +RZ#WR#DSSO\ #3)/#DQG#/,67(1

71;14 +RZ#WR#DSSO\#3)/#WR#D#FKDQQHO

■

■■

■

Press the PFL-button on the selected channel.

■

■■

■

Ensure the PFL-button on the Listen module is pressed.

■

■■

■

Ensure level is up on Master faders for monitoring through monitor speakers.

The signal to feed the monitor amplifier is taken from the Listen output on the rear of

the Listen module.

To monitor via headphones, press the PFL button next to the headphone level control

at the bottom of the Listen/Stereo/ output module.

71;15 +RZ#WR#DSSO\#3)/#WR#D#JURXS#RI#FKDQQHOV

■

■■

■

Press PFL/LISTEN CHAN HOLD on the FCM.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 138 139

Commentaires sur ces manuels

Pas de commentaire

Cadac R-Type Manuel d'utilisateur Page 34

Commentaires sur ces manuels