Typical Connecons
Power Supply
DSP
CSM
To further racks or control surface
To further racks or control surface
Comms link1 (Coax pair)
Comms link2 (backup)
Frame Control
The Control Surface consists of four frame components:
input frame
output frame
Central Control Module (CCM) frame
Control Surface Manager (CSM) rack
Input Frame
A single input frame has the capability to control 144 input channels in 8 layers or 8 user
assignable banks.
The input frame comprises:
> 18 input modules and fader modules (small parameter set)
> 1 input Central Assign Module (CAM) and fader module (full parameter set)
> 72 input LED bargraph meters
> 1 CAM display module, with headphone source selecon
Output Frame
A single output frame has the capability to control 66 output and 6 listen busses in 4
layers or 4 user-assignable banks.
Addional S-Digital frames can be specied to give dedicated hardware control over mulple inputs and bus outputs, mirroring the ability to link
mulple J-Type frames together. The headphone output of each frame can be sourced from any of the three stereo listen busses, thereby allowing
mulple operators simultaneously to congure and work on the desk.
The acouscally silent power supply units, housed in a 2U 19” enclosure, contain two independently mains fed supplies. These can power
individual system components or act as dual redundancy supplies. Status monitoring is provided locally to the PSU via the onboard
OLED™ display, in addion to being fed back to the Central Control Module via the HSD comms system. The power connecons to each
rack or control surface are on 6-pin Cannon connectors, with PSU status data connecng locally to each rack via XLR-3 connectors.
Central Control Module (CCM) Frame
This controls the system set up and runs Cadac’s Sound Automaon Manager (SAM2)
show control system. It also houses a bespoke control secon with dedicated one-touch
funcon keys, a high resoluon monitor, and housed in an independent 4U Control Surface
Manager (CSM) rack interface dedicated communicaon and control interface processors.
A Meterbridge
B Channel Mute/PFL/Sel
C Input CAM fader
D Channel status OLED
E CAM meter
F CAM module
G Mic pre controls
H Bus sends
I Input dynamics
J Input EQ
K Input fader
L Output dynamics
M Output EQ
N Matrix sends
O Output fader
P DC master fader
Q Output CAM fader
R Output CAM module
S Output CAM meter
T Master mutes
U P&N buons
V Custom keyboard
W MIDI and Event indicators
X PSU indicators
Y USB ports
Z Trackball
System Architecture Control Surface
4 5
Commentaires sur ces manuels